Back to Water MapKenya groundwater sample KE-08
Groundwater analysis for this sample, with English reporting and a WHO drinking-water reference comparison.
Sample evidence summary
KE-08 documents a groundwater source in Kilifi, Kenya. The reported source is Coast Water Works Development Agency. Use the selected measurements below alongside the complete results table and the source limitations when defining project requirements.
KE-08 records groundwater results for Kilifi, Kenya. Source: Coast Water Works Development Agency.
- pH: 6.3 (as reported).
- Turbidity: 3.2 NTU (as reported).
- TDS: 11300 mg/L (as reported).
This summary reproduces selected reported results; it is not a complete drinking-water safety assessment. Dates and reporting limitations are shown below.
Explore water reports from Kenya
- Country
- Kenya
- Area
- Kilifi
- Water source
- Groundwater
- Sample ID
- KE-08
- Sampling date / period
- 2026-03
- Report date
- 2026-03
- Source
- Coast Water Works Development Agency
- Version
- 1
Results and WHO comparison
SAMPLE KE-08 · REFERENCE SCREENING
What these results indicate
0 above reference / detected0 at or below reference / not detected4 not assessed8 context only
No result in this record could be conclusively compared against a numeric or microbial reference. Review the units, reporting bases and detection limits listed below each comparison before drawing a conclusion.
Microbial evidence gap: this record has no separately identified E. coli or thermotolerant/faecal coliform result. Total coliforms and general bacterial counts do not replace that test.
Unresolved comparisons: review the reasons beside each result. ND/BLQ without a numeric limit, ambiguous units and unspecified chemical forms are not counted as compliant results.
Treatment options for this sample
Evaluate reverse osmosis for dissolved-salt reduction
Trigger: TDS = 11300 mg/L; screening level > 1000 mg/L.
If the intended product-water specification requires lower salinity, evaluate BWRO with feed salinity, ionic composition, scaling potential and recovery. UF alone does not remove dissolved salts. Estuary or highly saline feeds may need a seawater-rated design.
GlobalUF screening trigger informed by WHO taste guidance; not a WHO health limit.
Explore Brackish Water Reverse Osmosis (BWRO) →Evaluate clarification and ultrafiltration
Trigger: Turbidity = 3.2 NTU; screening level > 1 NTU.
Review coagulation/flocculation and sedimentation for elevated or variable solids, followed by filtration or UF where appropriate. Confirm seasonal peaks, particle characteristics and organic matter; use jar or pilot tests to select pretreatment. Include a suitable disinfection barrier for drinking-water use.
GlobalUF raw-water screening trigger (>1 NTU); WHO treatment/disinfection turbidity guidance is context-dependent, not a raw-water health limit.
Explore Ultrafiltration membranes →Automatically generated screening from this sample record and the cited reference set. This is not an engineer-approved design, a national compliance certificate or a declaration that untreated water is safe to drink.
Source and interpretation
Results describe this sample only. They do not represent country-wide conditions or establish drinking-water safety.
This is a sample record, not a treatment specification. A process design needs a current, representative source-water analysis and the intended product-water requirements.
WHO drinking-water guidance is used for screening, not certification of untreated source water. TDS categories describe palatability, not overall drinking-water safety. Original dates and laboratory details remain in the source archive.
Download WHO Drinking-water Quality Guidelines (2026 PDF)WHO source document · PDF · approximately 6 MB
FROM WATER ANALYSIS TO PROJECT REQUIREMENTS
Discuss your water quality with our engineering team
Tell us about your source water, required capacity and intended use. Our team can help review the data and define the next engineering steps.
Consult our engineering team →